- Joined
- Jun 21, 2011
- Threads
- 225
- Messages
- 20,974
- Location
- Redding, California
- Website
- trail-tailor.com
4130 CrMo knuckle balls in the works.
J
J
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
What sizing Jason? 40/60/early70?
Or late 70/80/105 size?
Will the end fit in a 3.0” ID tube? If so I will take 2. Thanks!
Oh I didn't know you were going to be making the whole axle! I might wait....2.80" ---- 3.5" x .375 wall DOM is what I'll be using to build our custom axles.
Jason
I am curious, will you be selling 80 series knuckle balls and custom made housings separate or are these only offered as part of kits or shop swaps? I have been brain building a project for a while and getting close to needing a housing or knuckle balls if they will be available soon?
I will be building full housings soon, but mainly for my Customs shop. Have not decided if I will release just the balls.
J
@TRAIL TAILOR would these allow for 1.5” major diameter 35 spline inner axles to pass through them if the axle shaft oil seal was in the tube near the diff?