- Location
- United States
For sale is my 1963/4 FJ40. I found this 40 up in NW Montana in 2005. I used it up there for a couple summers and then brought it back to Arizona where it was stored from 2006-2012. I then brough it out to California and started taking it apart one rusty bolt at a time. While I was buying parts I noticed that some of the 64 parts did not fit correctly (tie rod ends). I did some research and found that I had 63 tie rods and a few other 63 parts. I was told that Toyota would often take left over prior year parts and use them on the next years vehicle. So I have a mix. The tub was media blasted, metal work done and then the entire thing was powdercoated piece by piece. seat frames powder coated, new seat foam and covers, soft top made by my pops, hardtop was damaged beyond repair by snow. I also have the corregated sides and bi-fold rear door with glass. All are powdercoated the same as the tub. I have bug catcher vent windows and rear jump seats. The engine has a factory mod with dual port intake manifold and 4 to 1 exhaust manifold. Has an electric fuel pump. The original mechanical pump is still in place. I am running a Rochester carb. Original oil bath air filter, aluminum E brake handle, original rear view mirror. It has Selecto front locking hubs, original locking gas cap. A very high end "Tilt-o-meter" was added to the dash at some point!
I now have a full Metal Tech "family" roll cage as well that is anchored to the frame and not just the tub.
I have boxes of hardware and parts form the resto so it will all go with the 40.
Please call me if you are interested or have question. Tad 773-255-5203. We can negotiate a price but I am looking at somewhere around 15-20K. There was a similar 65 that was priced at 14K which had a lot of rust and nothing done to it. I am open to suggestions for price.
I now have a full Metal Tech "family" roll cage as well that is anchored to the frame and not just the tub.
I have boxes of hardware and parts form the resto so it will all go with the 40.
Please call me if you are interested or have question. Tad 773-255-5203. We can negotiate a price but I am looking at somewhere around 15-20K. There was a similar 65 that was priced at 14K which had a lot of rust and nothing done to it. I am open to suggestions for price.
Last edited: