Anyone have a 40 series crossmember for a late model? It's the three piece tranny support....
40 series crossmember needed
- Thread starter rutbeer
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
will a 60 series work? If so I have one bolted to a trans
- Thread starter
- #3
I'm not sure.....do you have a measurement of it length wise?
Dude, welcome to the 66 lwb club! didn't know there were that many in NC.
Dude, welcome to the 66 lwb club! didn't know there were that many in NC.
Thanks it's a good club to be in. Are you working on a diesel swap? I am considering for my 45 but I haven't a clue which way to go.
I will try an measure it this week. It is in storage. I am usually in Winston Salem once a week so if you want it, I can meet up with you.
I will try an measure it this week. It is in storage. I am usually in Winston Salem once a week so if you want it, I can meet up with you.
- Thread starter
- #5
Yes, but I decided to put it in the 40 and leave the 45 alone. I will have an extra 13B-T available after a few months. I already have one, but I bought another just in case there was something wrong with the one I got. After I have had a chance to run both and do some tests, I'll offer one up for sale. You can check https://forum.ih8mud.com/showthread.php?t=60600
if you want to see how it winds up. Of course, if you are in town, it's easy enough to drop by every now in then. Hey, if you are in Raleigh, you might be able to take an intake manifold back to Krzykanuck for me. I got it from him a while back, but won't be needing it afterall.
if you want to see how it winds up. Of course, if you are in town, it's easy enough to drop by every now in then. Hey, if you are in Raleigh, you might be able to take an intake manifold back to Krzykanuck for me. I got it from him a while back, but won't be needing it afterall.
I'll be there Monday. email me your address and your phone number and I'll try to swing by.
