Looking for tips before I install my rebuilt rotary injection pump on my 3BII
1) Bleeding the system - any techniques? 3B manual just says to loosen the nuts on injection lines to nozzle and crank engine...
2) Regarding timing, I've got my dial gauge ready along with specs for travel at TDC. Any extra tips?
2) Should I lubricate / grease the pump's spline shaft?
Thanks!!
1) Bleeding the system - any techniques? 3B manual just says to loosen the nuts on injection lines to nozzle and crank engine...
2) Regarding timing, I've got my dial gauge ready along with specs for travel at TDC. Any extra tips?
2) Should I lubricate / grease the pump's spline shaft?
Thanks!!