Been looking through a lot of forums and need a bit of advice on some issues on my 2LTE
I'm struggling at getting over 10psi of boost.
Bit of info on the truck.
1992 ln130 4.88diffs lockright lokka front
33sx12.5x15 2 inch suspension lift
Winch bar
Water to air intercooled dual pass radiator
With 20L reservoir in back of truck
EGT boost water temp oil pressure gauges
Boost guage set up between intake manifold and filter
pneumatic air bleed with bronze filter too.
New ct20 turbo cartage.
60mm exhaust with high flow muffler
Ln165 radiator and shroud
Viscous fluid replaced and 10blade 1kz fan installed
Truck just ticked over 300000kms
I dialed up the spil control valve 1/4 turn 3 times to see if it would boost more but on third time rpm get stuck at 4500rpm and had to dump the clutch into third to stop the revs. Dialed it back 1/8
Goal would be around 16psi
Injectors just been overhauled new nozzles set at 155bar
Bit of smoke when running start up sounds like mis fires below 1150rpm set idle on 1200. (Possible worn rings but runs mint next to no smoke once warm.)
Any help would be appreciated
Cheers
I'm struggling at getting over 10psi of boost.
Bit of info on the truck.
1992 ln130 4.88diffs lockright lokka front
33sx12.5x15 2 inch suspension lift
Winch bar
Water to air intercooled dual pass radiator
With 20L reservoir in back of truck
EGT boost water temp oil pressure gauges
Boost guage set up between intake manifold and filter
pneumatic air bleed with bronze filter too.
New ct20 turbo cartage.
60mm exhaust with high flow muffler
Ln165 radiator and shroud
Viscous fluid replaced and 10blade 1kz fan installed
Truck just ticked over 300000kms
I dialed up the spil control valve 1/4 turn 3 times to see if it would boost more but on third time rpm get stuck at 4500rpm and had to dump the clutch into third to stop the revs. Dialed it back 1/8
Goal would be around 16psi
Injectors just been overhauled new nozzles set at 155bar
Bit of smoke when running start up sounds like mis fires below 1150rpm set idle on 1200. (Possible worn rings but runs mint next to no smoke once warm.)
Any help would be appreciated
Cheers