I have a problem with my 1HD-FTE that's been going on for a while. Car enters limp mode randomly when sitting at it idle (normally at trafic lights. Doesn't happen always, can happen in a couple of days or in a couple of minutes).
Car has OBD 1 and i have read about connecting the pins together in the diagnostic port to make the Check Engine Light flash in order to read the code out.
Problem is, to read the code I have seen that i must first shut the engine off.
When I turn the engine off and back on again ,the limp mode goes away. Thus, I can not read the code.
Anyone have any suggestions?
Thanks!
Car has OBD 1 and i have read about connecting the pins together in the diagnostic port to make the Check Engine Light flash in order to read the code out.
Problem is, to read the code I have seen that i must first shut the engine off.
When I turn the engine off and back on again ,the limp mode goes away. Thus, I can not read the code.
Anyone have any suggestions?
Thanks!