I want to plug the two holes on top of the tub at the back of the door openings where the cab rods go when the top is on. I don't want water getting in there because at some point it would have to contribute to body rust. What's out there that your using as a temporary plug for these holes?
After getting a misfire code on number 4 and 8 I thought it was just a coil. I drove it another mile home and pulled #4 and after removing the bolt the coil and plug all came out together. #8 looked fine, but as you can see #4 is FUBAR.
I tried screwing in another plug and threads in the...
Thanks to this forum I decided to look for my cold start up tick by looking at my plugs. Found it! More than likely saved many $’s.
I am not sure when the plugs were changed but all but 2 I would consider loose.
Sounds like a couple cylinders. Took all apart and checked plugs are tight and leads are on.could it be another issue?
found this hose and don’t know where it goes I guess it vacuum? Second pic shows where it comes from
Hello all,
I did something wrong when I wired up some Anderson style connectors (am I getting the vernacular right?) with my main battery. I was tired of removing the LX plastic panels when I needed to use my compressor so I wired up a breaker and another connection to my battery. It works...
I have a 1989 hj75 2h and I’m trying to order some new glowplugs but every site only has ip to 1988 and I’m not sure why, and anybody know the voltage that my glowplugs would run because there is heaps of differnt options! Cheers
2010 GX460 with ~225k miles, owned 10 years and it's been solid. Historically, the dealer has done any work beyond basic maintenance and I've been happy with them, but as I've modified the vehicle over the years I'm transitioning to a local Lexus/Toyota specialist. This shop repaired a newly...
I'm looking for a supply of Male and female 6 pin tail light harness plugs and terminals.
I want to make a jump Harnes between the existing tail light plug, but with pug tails for a 4 and 7 pin trailer harness.
Can anyone reccomended a clsource for those connectors?
Thanks
First symptoms : Loss of power code 26 now after all had been done (below) I’m getting code 21 and LC still has lack of power except that it’s idling a lot better now but still slugish power when in gear . Had a Brand new cats and o2 sensors . 1994 LC 80 series
New fuel pump
New fuel filter...