link

Getting ready to pull engine from one of the shop 80s so figured this comparison would be best done before that. This video compares relatively new (2-3000ish miles) OEM drag link to our 7075 drag link. The difference is noticeable. Decided to make these after a recent cross-state dirt road...

https://bringatrailer.com/listing/1964-toyota-land-cruiser-fj45-10/#comments-anchor Thai one is up for sale. Please pass the link to people that are not necessarily internet folks that might be interested.

The smaller black wire from the fusible link block melts when I connect power during a jump start. In the picture it is the wire that was soldered together. What are my next steps and parts required? Also what does the soldered wire go to that may be compromised? In the second image is a red...

Whats up with Enduro joints ? I got them for frame side of 4 link , dam things are 2 & 5/16 NOT 2 & 5/8 as the brackets are.

Just curious. How important are these to the rear stabilizer setup? Got the bolts torqued down to 19ft.lb, but the bracket does seem a little bent. These got mixed in with all the tools on my garage floor while replacing rear springs/shocks. Did not notice them until everything was put...

Hey guys, wanted to share a video series on this 80 build. We’re doing a 3 link conversion with coilovers, hydro assist, high steer, big brakes, 40s along with a bunch of other cool mods. We have Part1 on YouTube, check it out

Just curious if there was a factory standard orientation of the steering link clamps and associated bolts.

Ever see this before? I’ve heard of bending the tie rod but not it breaking like this. Looks like it napped right where the link ends. Thank goodness this happened when pulling into my garage but so bizarre. Who makes the best replacement rod kit? Might as well upgrade but I don’t need...

Hello, I'm looking for both rear lower control arms and the lateral link from a 100 series. Bushing condition doesn't matter. Links must be straight. Located in Monterey, CA. Will drive a bit to get them. Thanks.

What was the OEM gauge for a fusible link on a 1978 FJ40?

Hey everyone, bought this 40 series a few months ago and am in need of new drag link ends. Stock ends didn't fit, too small in diameter. Someone from an earlier post of mine stated this looks like a mini truck steering set up. What ends should I purchase to replace what I have on her? Thank you...

I’m looking for an hdj81 fusible link does anyone know where to get one? I can’t find The japanese 1hdt fusible links in America.