differential rebuild

Got this diff with my LX when I bought the truck from the previous owner. She said that the shop that was working on it sourced it from a junkyard when her parts were on backorder. Parts ended up coming in sooner than expected and she opted to keep the spare diff. Everything should work but I...

I am redoing both knuckles on my '77 FJ40. I also decided to crack open the front differential and just check for signs of wear or any breakage. Everything looks good. Couple questions: 1. The differential fluid was a gray sludge due to leakage of grease from the knuckles into the differential...

I want to rebuild the 7.5 inch differential, F302, in my 83 pickup, 22R, 1/2 ton, 2WD. I’m looking for information on the SST 09530-30012, Differential Drive Pinion Adjusting Gauge. I know there are other ways to set the pinion depth, but for now I’m hoping to find out whatever I can about...

I'm rebuilding my 1974 FJ40 rear differential. This is my first differential rebuild of any kind & I can use some advice from the experts. I've replaced all the bearings but keeping the original ring & pinion gears. The attached photos show two attempts to get a good gear contact pattern. The...

Hey all, Currently rebuilding the rear diff center out of my Hdj80. I’m currently on the smallest pinion shim I can get from Toyota 1.05mm My back lash is 0.17mm The gears are used and I’m only rebuilding as pinion seal was leaking and decided to put a solid spacer and new bearings whilst I...

Just wanted to get the word out that I am rebuilding differentials on the side ( I am a technician at Toyota). Pulled out is preferred, can r&r if needed. Pricing will vary depending on the model, if lockers are added, etc. Best way to reach me is by email: fmj4x4noco@gmail.com or PM. Thanks, MJ

Hello I am currently replacing my pinion seals and bearings. Here are a picture of my ring and pinion gears. Are these still good or look worn? Thanks! 1995 cruiser 287,000miles

Looking for someone that can rebuild my rear differential. It’s a 78’ FJ 40. I live in Chicago... Thanks!

So I bought a fj60 at the start of the summer and as expected it had been previously neglected and a laundry list of repairs needed, after replacing master cylinder, front calipers and pads, wheel bearings, rear brake shoes and wheel cylinders, rebuilding knuckles and birfield, thoroughly...