Search results for query: *

Forum search Google search

  1. olivertwist

    Help! - Lower Tailgate won't open

    I've searched the forums, and googled, and most of the tailgate issues are relegated to the top hatch not opening (from inside and/or outside). However, my issue is that the lower half won't open. As far as I can tell, there is no locking mechanism in the bottom half, so it doesn't matter if the...
  2. olivertwist

    Thoughts on warping Rotors ?

    I've gone through TWO sets of rotors now in under 15k miles!! :bang: I purchased my built cruiser with 103k miles on it, and according to the friend I bought it from was running OEM rotors and pads. At about 151k miles, I finally replaced the front brakes with OEM rotors and Terrain Tamer pads...
  3. olivertwist

    24v Alternator - Troopy/Coaster Bus

    The Troopy has been mostly dead since I took delivery, except for a couple jump pack starts to move it in the driveway. Today I put two fresh batteries in it and fired it up so I can see if the alternator is putting out a charge. Nothing. No change in voltage. First step is going to be to take...
  4. olivertwist

    Belgian Maltec(ish) Troopy

    It's finally arrived! Time to start building! Last September I bought a HZJ75 in Belgium, took it to Maltec in Germany to fit a pop top roof on it, and then brought it back to Belgium to depart from Zeebrugge... right as the entire world was shutting down. So it sat at the Port for another good...
  5. olivertwist

    Pre-Build - Troopy Electric options 24v to 12v

    I'm almost to the point where I'm ready to start a build thread - my '94 Belgium bought Troopy is with Maltec in Germany finishing up it's pop-top conversion, and I have a 1HD-T being rebuilt for install when I have the Troopy in the USA. I've received a lot of great guidance from many of you...
  6. olivertwist

    Replaced MFD NAV Screen.. Still Broken

    I posted in a previous thread when my touch screen on the MFD went dead. It was due to a crack from a suction mount that had been affixed to the screen by the prior owner. I replaced the screen & digitizer with a new Toshiba part, and everything was fine again... until about 2 weeks ago. The...
  7. olivertwist

    Wanted  Armed Forces or MUD Members Abroad

    MUD - As most of you know, finding a 2003-2007 Cruiser with Factory Non-Nav in the States is damn near impossible. I'm looking to make the Nav to Non-Nav swap a reality here, and need some parts to get the project going, which will be fully documented once underway. So, here's where I need your...
  8. olivertwist

    MFD Touchscreen dead + Non-nav swap update

    The MFD touchscreen on my 2006 LC just became unresponsive to touch. The screen still works fine, and there are no error messages like "External System is not connected" or any of the others that I have seen posted in here. Next I went into the Service Check Mode, and all functions say OK, other...
  9. olivertwist

    ARB Rear Bumper adjustment Question

    I just picked up a built Cruiser from a friend, and have some questions about the ARB Rear Bumper. The right side swing out with the tire carrier seems to sag slightly, which makes it difficult to open and close the swing out, as it hits the little plate mounted on the bumper. I've included...
Back
Top Bottom