OK, as I'm lining up the parts for my subtank install, my dog grabbed the fuel sender and got a good chew in before I noticed. Young Aussie, they love to chew....
The harness connector is shot, but not an issue as I'm cutting it off and using my own.
However he also bit the fuel float for the...
I started looking for a rear bar for my 80 a few months ago. My goals were as follows;
- Decent price
- Dual Spare Tire capability as I drive on sharp rocks in Nevada and have had a lot of sidewall cuts and punctures. Even with patch kit/compressor always a stress point. I...
Looking at ordering the Kaymar Ozbar, something they introduced recently.
OzBar Rear Bars, Spare Wheel Carriers, Jerrycan Holders & Accessories
It seems to be meant to be a lower cost option compared to the standard Kaymar, more industrial in nature.
I really like the fact that it does not...
So after some deep muddy water crossings I got about half the idiot lights on my dash coming on. After a search I tried cleaning out the alternator with water, and banging on it a few times, whcih fixes it for a few days, then I need to bang on it again.
I'm assuming there is enough gunk in...
OK, I'll post some pics as well...
Mine is an 88.5, I bought it after "discovering" nevada while going on some dirt roads in a Dodge Intrepid.
It was really my introduction to off- roading, and I still love it, although my Land Cruiser has become my primary desert trip vehicle.
When I...
Hi All,
I plan on adding a tablet PC to my 94 80. I would like to use the bolt that is in the center console front cubby under the carpet. Specifically the cubby that is between the armrest and the shifters.
The bolt looks pretty big, and strong enough for what I am doing, but I wanted...
Just need to get rid of it. It is not perfect, as it has been in San Francisco for a while and subject to the minor usual minor dings and nicks. It's in the North Bay, but I can have it in San Francisco as well.
I am willing to ship, but would charge $40.00 + actual shipping cost.
Comes...
I have the cold weather noise/vibration, amazingly loud when it happens. Fortunetly this is once in a blue moon, and only last a few seconds. Other threads point this to dry bearings.
I'm looking for opinions on how time critical this is to fix. I have a 1000 mile trip, with some off road...
I started getting a bearing noise from the engine area, and found it to be the A/C tension pulley, which I am in the process of replacing.
While looking through the FSM I noticed there is a tensioner/pulley for the twin drive belts as well in the pictures. My rig has no such pulley in place...
OK, so I'm driving around yesterday, and off to the side of the freeway is a giant mud/water area. Naturally I got off the road, and proceeded to drive through it a few times. Of course this was only to give my lockers some exercise, as recommended here on the board:rolleyes:
The water was...
Hi All,
While removing a wheel lug from the right rear of my 94 LC, I broke one of the studs. (Wheels were last removed by the dealer, I assume they used air to tighten....). After searching the forum it seems possible to hammer the stud out without removing the axle, then manuever the new...
Hi All,
Greetings from a TLC newbie.
Took my new (94, locked) TLC on its first expedition a few weeks ago, and came up with an issue I wanted to ask about. Before going I added BFG M/T's and Hanna sliders. Love the sliders, had I left the running boards I would have had a problem...
I...