Dog bit the Fuel Float for sub tank

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 11, 2005
Threads
15
Messages
81
Location
San Francisco
OK, as I'm lining up the parts for my subtank install, my dog grabbed the fuel sender and got a good chew in before I noticed. Young Aussie, they love to chew....

The harness connector is shot, but not an issue as I'm cutting it off and using my own.
However he also bit the fuel float for the sender, and it has some puncture marks. As I look at it I don't see a hole, and it appears the float is solid not hollow. No air seems to move though it, and it passes the bubble test, but does anyone know if this is a solid piece, or hollow. If hollow it could fill even from a pinhole, but if its solid I'm probably OK to install it.
Really don't want to have to drop the tank if the gauge stops, but I also don't want to buy a new sender..

Everything else on the sender is undamaged.
 
Pic

8EF32313-AB8B-4109-BF1D-B2356275D66C.webp
 
Little dabs of plastic epoxy would insure they wouldn't ever leak. Wouldn't add enough weight to the float to make any difference.
 
That doesn't look too bad. Last time I did U-Joints the dog took one of the cups. Ended up buying a whole new U-joint because the cup was GONE! Found it in the yard about a month later. Stupid Dog.
 
Good idea, put a little JB weld in the holes as insurance...

Opinion= run it or replace it...there's no epoxy or other product I would soak in gas for an indeterminate amount of time which will inevitably wind up in your fuel filter or worse...POR 15 IIRC has a putty or epoxy that is supposed to resist gas, having said that the float material may not bond correctly and separate regardless...post a pic of the pup!
 
Are you going to cut the access hole over the sub tank ? If so, it’s not the end of the world to pull the assembly if it does not read consistently
 
Keep him away from your kids homework ;)
 
Back
Top Bottom