Hi all,
I am looking for some clarification on what airbags (safety feature) were available on the HZJ105. Were only front airbags available or side and side curtain too?
Thanks.
Free H42 4 speed transmission with approx 250k miles. Had quite a bit of gear and/or bearing whine but worked fine when used last. Easy to shift/no grinding. Longer style with the spacer.
Pick up in Memphis, TN.
Hi,
Over the last month, it has been increasingly difficult to shift my h55F into 1st/2nd when stopped and has gotten to the point now where I almost cannot shift into gears if I'm not at least rolling a little bit. For a while only 1st was hard to get into, now 2nd is as well. If i'm moving, I...
Hi all,
I recently came across a few forum posts which indicated that 1HZ engines from 105 series models had weaker internals than the same engine found in other models--perhaps 70 and 80 series trucks. Can anyone elaborate on these differences, if they are in fact true?
Thanks.
Hi all,
Read countless threads in which the fuel economy of different Toyota diesel engines was discussed. What would be the most fuel efficient land cruiser diesel engine regardless of cost, parts availability, power, and other such considerations for a 60 series wagon? Options include 3B...
Hi all,
Would like some help diagnosing or at least theorizing possible causes for an engine stumble / patch of rough running which lasts from 1800-2200 (approximately) rpms only in 3rd gear. This issue has been going on for several years.
I have an H55f transmission and the original 3FE...
Apologies in advance. I searched but could not find a clear answer. When rebuilding or resealing a transfer case, is it recommended or required to coat the output shaft bearings and the idler shaft bearings in grease?
I had to rush through my t case reseal. it had been about 8 years since I did...
As I was resealing my Transfer case, the spacer on the back of the h55f came loose and fell down on the output shaft of the tranny. I ended up with a detent ball on the floor. Also now the black rubber grommet no longer connects to that silver piece. I would try to reconnect them but my silver...
I might be relocating to the DC area this fall. I'm worried about exposing my FJ62 to the winters and the accompanying salted roads in this area. Is this a valid concern? Currently, my truck is pretty much rust free and I want to keep it that way. I never drive it when it snows and that's...
Can someone recommend a strong car wash soap or spray that is really good at removing grease, dirt, grime and all other contaminants?
I've used some armor all cleaning wipes and spray cleaner, but I don't want to continue using it since I don't believe its designed for painted surfaces.
Thanks
I'm having an issue while my air conditioning is running in 70+ degree weather. When I use the ac, my engine compartment temperatures seem extremely high. The fan clutch is completely locked up, 100 percent of the time whether I'm on the interstate or driving around town. Additionally, the...
I wanted to force my engine into open loop for diagnostic purposes, so I disconnected the 02 sensors. After doing so, the engine will not start. I did not think the 02 sensors had a crucial impact on engine management until operating temperature had been reached. Does anyone have experience with...
Does anyone know where I could find an adapter fitting for the high pressure side of my AC compressor which does not require the removal of shrader valve in the original ports? I have one adapter that seems to have worked fine on the low pressure side.
Thanks
I've got a 3FE and and with an H55F swapped in. There is a noticeable stumble and interval of rough running/vibration right around 2000 rpms in 3rd gear. It will rattle the dashboard slightly, but it is very noticeable and happens consistently. If I push the throttle to the floor, it smooths it...
I'm looking for parts to convert my FJ62's transfer case from vacuum shift to mechanical shift. I need the parts circled in red in the below diagram.
Thanks.
Can anyone share data on the 3FE fuel injector flow rate? Better yet post some results from injector cleaning? I had my injectors sent off and cleaned but the report I received has specifications for an incorrect engine and/or injectors.
I'm not sure how meaningful my results are but the report...
Selling a set of 5 16" OEM Toyota split rims. They are in good shape but have some minor surface rust or imperfections. The last picture shows the 'spare'. It is a slightly different style than the other 4.
$400. Located in Memphis, TN.