My 2f will stall out ideling with the brakes on. Would a bad brake booster cause a lean idle condition? Is there a way to diagnose a faulty booster? I've removed and capped all vacuum line and it starts and runs just as well as it has since the motor was installed.
Oh, it feels like I'm not...
So, I went to a mtb festival yesterday and road a couple of bikes, about 3 miles each. Some climbing and some technical descending. The new bikes are amazing. The last bike I bought was in 08, Fisher Hifi. I was very impressed with the climbing ability of the 150mm enduro bikes. Now I want a...
I'm finishing the last details on my '70 40 and have an issue with the fit of the barn doors. The edge of the doors near the hinge interfere with the body. I've tried loosening the fasteners and pushing everything toward the center to clear the opening, but there's not enough clearance in the...
I need some help with determining the connector wiring on my gauge harnes . Please refer to the photo
https://goo.gl/photos/4kiQdFq3PUXeAHB57
Can someone clue me into which plug mates to C on the cowl wiring harness in the 69-71 FSM?
I have a functional speedometer thanks to everyone how...
Anyone carrying a bike on their bike? I know there are one or two commercially available ones but I think the cg of the bicycle is too high. I have an R1200GS and thinking of mounting from the crash bars and vario case. Anyone done something like this?
Just found this product. I finally have a space that I can use as a shop and need a small fab table. I would like some feed back from the guys that do this for a living. It's not a Demmeler Table but I don't need that. A bike frame would be the most complicated thing I would probably build.
Has anyone welded riveted wheels and then grind down or removed the rivets?
Someone local to me is selling 4 stock riveted FJ40 wheels and hub caps for what I think is a low price, but I have a disk brake conversion. Am I being too cheap?
I have a project that requires some tubes with 180° bends and I don't have the room or budget for a bender so I thought I'd would see if there's a good source for off the shelf bends?
I've found a couple of places:
http://www.sharpeproducts.com/store/pipe-tube-elbows...
I'm looking at options for an afordable replacement dash pad. I know of at least two options to new replacements, TPI and FJ40dash.com. Does anyone have feedback on either of these options. FYI 1970 40.
I'd like some opinions before I purchase
and how do I recover without spending too much more? I thought I was getting a deal on a 302 and tranny (E4OD). Now I'm kind a stuck on installing it in my 1970 FJ40. I'm thinking of selling the E4OD and getting a C4 or C6, but I would welcome any advice on this subject.
I've not been able...