I have a ‘79 2f with fresh rebuilt carb from Mark A. Truck starts like a dream and as I depress choke, the thing idles at around 1400. I haven’t got the idle down to 650ish yet. Vacuum gage hovers at 17 inches. Drops when you mash the accelerator and then tops at mid 20’s when you let off...
could someone please post up pictures of the bi fold door from inside the vehicle? I have the “safety latches” and the hooks on the door. I need to see how the latches attach to the sides. Does the perch sit above the top or ha g below the top? The SOR diagram looks like thee go up, but I’m not...
Will a 75-1/79 manifold work on a 3/79 2F? Most threads show they are different, but $OR and a few other places have the manifolds lumped together. Have the 75-1/79 manifolds found, but they will do me no good if they don’t mate up w my block.
Thanks in Advance
Guys, I have scoured through build threads and searched for pictures of the engine bay but haven’t found what I need. I’m really just looking for some pics from fender to fender to see wiring, horn placement, etc. a broad pic that incan zoom in on is fine.
Thanks guys!!
About done with all the work involved in swapping a new to me ‘79 2F. The 2F was “running when pulled for a SBC conversion 20 years ago”. Head pulled, decked and inspected. Everything bolted back up and engine was started but no oil pressure. Killed the engine, installed a mechanical gauge, and...
ive got a ‘65 fj40 with a ‘79 2F/4 speed/3 speed t-case.
The clutch(new) is on the drivers side. I’ve done research and see it should be on passenger side. Will it work on driver side or does it have to be changed?
Thanks
i took the formula for Shell Ivory off here to my paint guy. Got some mixed up and sprayed the bezel. It is a creamy color, is this correct? Don’t want to shoot the hardtop to match if the cream isn’t correct. It’s on a 65.
TIA
i have a ‘65 40 that I am painting. I did the bezel in the shell ivory formula found on mud. It looks good against the spring green, but I’m not sure I have seen a pic of a roof that wasn’t “white”. The color on the bezel has a yellow or cream hue to it. Does the top match this or were they...
guys,
Looking for some advice. I’ve got a ‘65 single circuit truck and I am going to swap in a ‘76 disc front axle. Truck has a 2f in it, and I am trying to determine what master I need. I’ve got Mark’s adaptor to clear the rib, but want to make sure I get the correct master. (Going to run non...
Does anyone know if the rubber "boot" that connects to the heater box is available? Maybe a repro, if so is it decent quality? PO wrapped tape around the cracked, delapadated piece in my rig. Any insight on where to get this piece is greatly appreciated.
i have 5 - 32x11.50x15 BFG ko2 mt's.
Tires are an easy 80%, probably more than that. Come on wagon wheel rims that were painted over and probably need to be blasted and repainted or powder coated. $550 plus the ride.
Located in Arkansas, 72501.
Thanks
ok, after a week of reading the Bedliner pro's and cons in the FAQ's, and doing research on line I have decided I need to, "ask the experts".
I have a '65 that I am rebuilding from the ground up, 2f/4 speed upgrade, front disc axle, and body work paint job. The inside of the tub (rear) has some...