Another oil pressure thread

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 15, 2007
Threads
54
Messages
252
Location
Arkansas
About done with all the work involved in swapping a new to me ‘79 2F. The 2F was “running when pulled for a SBC conversion 20 years ago”. Head pulled, decked and inspected. Everything bolted back up and engine was started but no oil pressure. Killed the engine, installed a mechanical gauge, and tried again. No pressure. Pulled the dizzy and used a screw driver. The drill had to spin wide open for quite a while to get minimal pressure. Very little resistance on the drill, too.
Will drop the pan and replace oil pump this week.
Thoughts on other issues? There were 8 quarts of oil, I know I need another .5 quart, but would that cause the pressure issue?
Looking for thoughts and suggestions.

Thanks
 
With no prior baseline on the engine how do you know this wasn't an already existing issue?
Compression test prior to pulling the head?
 
Compression numbers good, I’ve got them somewhere (2.5 year project) but you are correct, I have no way of knowing other than the word of the P.O.
I want to say compression numbers were 135-145, but I’ll have to find my notes.
Just looking for some other possibilities. Since the drill didn’t spin the pressure up, I’m hoping it’s a pump issue
 
8 quarts wouldn’t be the reason.
I wouldn’t expect much oil pressure from the drill.

Which grade of oil did you use?
Could the oil filter not be filled up?
When you replaced the head gasket was it the same as the original?

It’d think it’s more likely that the oil pickup is blocked than an oil pump stopped working... but who knows.
 
X2 on pick up being clogged. That’s my hope, for sure. It appeared to be original HG, and no signs of prior entry into engine.
I used rotella 15-40.

Thanks for the posts.
 
Here’s simple test.

After reinstalling the distributor it is essential that you verify that the oil pump drive is engaged. You would not be having problems with the hold down clam if it was all the way in. Pull the coil center wire, remove the oil pressure sender and crank the engine for 5 seconds to verify that oil is squirting out of the sender hole.
 
Back
Top Bottom