Search results for query: *

Forum search Google search

  1. KC masterpiece

    SOLD  2f Carb Hat / Non US FJ 60 Air intake

    Looking for a 2F carb hat or ideally a complete non us air intake assembly from fender to carb. Thanks,
  2. KC masterpiece

    Kut Snake Flare Install

    After installing a set of Kut Snake flares over the weekend I wanted to post up a thread on the install process. It was somewhat straightforward but I found myself wanting more info during the process. I purchased the flares from @c2dfj45. Fast to respond, fast to ship, and answered all of my...
  3. KC masterpiece

    Mr. Green Genes - A Build Thread

    Well after lurking for the past five years and finally purchasing an 80 series in December 2018 I figured it is time for a build thread. In September of 2013 I picked up a 2008 FJ Cruiser and spent the next few years modding it out and falling deep into the 4x4 rabbit hole. Eventually I ended...
  4. KC masterpiece

    Occam's Razor

    Driving into work today my throttle felt a little sticky. My cable jacket is torn up so a replacement was on the to do list anyways. No big deal.... Pulling up to a 4 way stop I suddenly had no power brakes and the tac was still sitting at 3k even though I was off the throttle. I had to lay on...
  5. KC masterpiece

    Is My Transmission Dead?

    Howdy Folks, Well I think my transmission has died, but I wanted to get a few educated MUD opinions before moving forward with a replacement. I will try to include as much info as possible below and would highly appreciate all your input. Vehicle Info 1997 FZJ80 - 187,xxx miles Original...
  6. KC masterpiece

    Normal Knuckle seep?

    Completed my axle job a few weeks ago. Since then I have been driving quite a bit for work and have put in about 2500 miles. I have checked torque on my knuckle studs and wheel bearings. Everything seems to be nice and tight. Most of my driving is over mountain passes around 12k so lots of hard...
  7. KC masterpiece

    Trim Identification

    When I purchased my 80 this trim piece was sitting in the back. I have no idea where it goes! Nothing seems to be missing.
  8. KC masterpiece

    For Sale  FJ Cruiser Tube Doors - Silverthorne, CO

    Metal tech tube doors for the FJ Cruiser with mirrors and nets. Like new other than one net snap that needs repair. $650 new... $450 local pickup.
  9. KC masterpiece

    Buzz from transmission

    Evening folks, I have a 1997 with 177k. After a recent trip of about 2000 miles I noticed a noise that I finally narrowed down to the transmission bell housing. It is best described as a metal on metal buzz. Based on my forum digging I have narrowed it down to a few options and hopefully...
  10. KC masterpiece

    For Sale  Silverthorne, CO - FZJ80 Weather Tech Cargo Mat

    Rear weather tech cargo mat. Installed a set of drawers and no longer need it. There are a few small tears from the rear seats. Matt is clean otherwise I just stepped all over it before taking the photo. $50 sounds good to me.
  11. KC masterpiece

    Engine stud identification

    Drove from CO to MO which turned out to be a nice shakedown run for the 80. Temps were a little high so cooking overhaul is definitely on the list. I was giving the engine a lookover this morning and found a sheared stud and it's nut sitting in the passenger side engine mount. Any idea what...
  12. KC masterpiece

    New LC Owner - From 2008 FJ Cruiser to 1997 FZJ80

    Time for an introduction. I have been browsing the forums for a few months in preparation to purchase an 80 and finally pulled the trigger just before the Holidays. I am now the proud owner of this fantastic low mileage 1997 currently sitting just under 170k. I have not performed any...
Back
Top Bottom