Search results for query: *

Forum search Google search

  1. T

    Where is the place to get 1fz 97 motor

    I have a 97 cruiser that has a bad engine , would it be better to rebuild it or just put in a new engine ? I’m not sure of what had happend but the motor is toast . The engine won’t crank and the crank pulley will not turn by hand .
  2. T

    Any fj80 owner in winder ga

    Is there any fj80 owner in Winder Ga? I would like to see how their rig ride in comparison so I would know if mine is riding right . I would like to know more people who are familiar with this rig.
  3. T

    Any fj80 owner in winder ga

    Ive seen a few fj80 in Winder Ga , I'm wondering if any of the owner are on here . I would like to meet some of them and learn from the ownership of these rigs.
  4. T

    92 fj80 brake line issue

    My 92 is out of commission dued to a crack head . I was losing brake fluid and realized that the rear brakeline has rusted out . I'm planning on cutting the line from the middle and adding on another to the proportion valve . The line is rusted out so I couldn't remove it from the valve...
  5. T

    leaking valve seat 3fe

    I have another thread on a sludge issue that I have with my 3fe . Then I found out it had coolant leaking from the valve seat . I was trying to figure this all out . If the valve seat is leaking coolant doesn't that mean that the cylinder below it should be full of coolant ? I don't quite...
  6. T

    92 landcruiser sludge issues

    Today I cranked up my 80 and like usual the lifter ticks like a diesel, so I decide to check the oil filler port . I notice a small amount sludge was inside ,so I check it with my finger after I cut off the engine . I felt more sludge . I took off the valve cover and almost pass out . There...
  7. T

    swapping birfield

    Hello fellow Fj80 owner, I'm new to this forum and this is my first Landcruiser or SAS rig. I recently acquire a fj80 free from a family member . When I receive the truck I was advise that both axle are popping . I have read a lot about the front axle on these solid setup on these Yota . I...
Back
Top Bottom