Good afternoon. While trying to get things setup for my Wits End QPM I tried locating the hardware kit that came with it but misplaced it.
Basically need to thread pitch for all hardware that came with the kit.
Thank you.
Good morning CSC. I am thinking about doing a 3 link setup but maintaining the factory spring/shocks location. A fellow MUD member from California did it and it looks really good. I know I will be limited with the amount of flex with the factory spring/shock location but I am looking for a...
Happy Sunday!!!
Where is everyone taking their 80 series to get the alignment checked? I am having a wear issue on my front tires and want to make sure the toe is adjusted correctly and see how far caster and camber is out. I am wearing the outside of the front tires.
Thanks in advance.
Good morning.
Recently my AC button on my control panel went bad, the bad circuit board was replaced with one from a newer 80 series.
My question is are the climate control panels interchangeable from the 94 on up or are there differences?
I know there are some with automatic climate...
We just had our water softener company by and they informed us that our water heater is 13 years old and should replace sooner than later, also our water pressure is too high.
So I am looking for recommendations on a company or private individual to install a pressure reducing valve and get...
Would I be okay with having 2 ground, 1 for the black/black wire "under battery" and then a 2nd ground closer to the switch ie "1" vice splicing in and having one common ground?
Photo credit @NLXTACY
I am looking to get out and enjoy the snow and do some wheeling and get the dog out to play in the white stuff.
Would anyone be down to go Saturday? Do not know the trail and would like to go with someone just in case...
Also, does anyone have a good map of the trail?
The wife and I are looking for painters to redo the exterior of the house and down the road do the interior.
We want someone that will not cut corners, that will fix stucco, move rock away from foundation, seal foundation, etc.
Please let me know who you have used and if you would use them...
Good morning! I am looking for the center section of the early FJ80 steering wheel, my horn does not work and I assume it is the structure of the center section of the steering wheel that is to blame.
Picture of what I am looking for...
I am looking to sell my 94 Land Cruiser. It has approximately 245k miles on it and the head gasket has been replaced.
It does not run top notch, there is a rough idle which I am chalking up to a vacuum leak or fuel delivery issue. The injectors were cleaned when the main engine harness was...
I follow a company called QC Motorsports and they have come up with a solution to the shortage and maybe the future of the fusible links being harder to find due to supply issues.
QC Motorsports Fusible Links
What is everyone's opinon? I might pick one up for future projects.
I am curious if anyone has done the seal replacement. Yes I did use the search button. I am looking to do this over the weekend. If there are no responses this will turn into a DIY.
I know this should be in the 80 tech section but I would like to keep it local.
So awhile back I bought some Battle Born wheels in 17X9 with a 4.5BS, they no longer carry that backspacing.
If I was to buy the 3.5 backspacing and run a 1" spacer on the 17X9 4.5BS would that give me the same...
An old employer/friend of mine knows how much I love Land Cruisers and reached out to me the other day. His neighbor has a 100 series Land Cruiser that recently dropped a cylinder. The undercarriage is super clean no rust, all bushings have been replaced, new upper control arms, new CV axles...
Good evening all. I am wanting to put in a extended differential breather kit. Has anyone used the stock union that is already installed in the front axle, if so what size hose did you use? Or is it best to order new union(S) for the front and rear? Is is best to use new breathers from Toyota or...