Recent content by thrashattack

im looking for a 3rd member with 4.37s in it. also intrested in a gear set if you have that too

Can u swap a wrist pin with out pullin the head? And do they need to be pressed in?

any comments on this ?and i going to be going th same thing and wanted to know if there are any tips or advice

I need advice on my steering on 1979 toyota pickup 4x4. it has the stock pushpull and i has considering hi steer. but im running the ome 2inch springs and some sites/people say u need a minimal 4". so is any one else running a old man emu lift with different steering? or knows a better steering...

i grabed a bracket off a chevy inline 6 and top bracket from the junk yard. welded on piece on, so it look like a L and used the bolt holes on the passenger side, spaced it with washers.its been over a year no problems. the stock alternator is still in place all hooked up just no belt on it. its...

wow?! who would thought i would have created a debate on transmissions. who cares. im ok with a carb. i wanna keep it simple and just alittle more power

So i have a 1979 toyota 4x4 pickup with the original 20r i like it but it getting tired. it was a webber and a header. i just threw on a new head gasket but i figure may its time to replace it. So do i stick with a 20r or do i go with 22r. I like the fact that the 20r is solid but a few more...

so you got gears from advance and they have not broke therefore marlin is the best. ok this like a ford ,chevy thing i dont get it

went with trail gear. marlin and tg are cut in usa the steel is from who knows where. the tg kit came with the same Japanese bearings as advertised by marlin. so i spent a 130 less who cares

anybody have the marlin crawler comp. 4.7 kit? on sale for 410

i did. i like ngk better

anybody? anybody who knows anybody? is tg sucks and tg breaks i wont buy

so i think about the marlin tcase low range kit but want to know who broke a trail gear kit?

or do i spend 80 on a spacer. i found a used drive shaft for 40 but it out of a 90s truck

i know the patter is different . but i have a swaped in 5spd and not the orginal 4spd. is my tcase is farther back ,i would think