97-99 Tacoma front bumper valance wanted
My kid has a 99 Tacoma that needs a new bumper valance. It's the plastic part that is below the front bumper.
Email me please: firstname.lastname@example.org
or call: 1-920-526-2200
Need: Oil pan & exhaust manifold
Would like to find an exhaust manifold to fit my 74 2F engine. This is the one piece manifold. Heat riser need not be present or working.
As well: NEED to find a NON-LEAKER oil pan. Already bought one, put it on and it leaks! Looked nice but I think the PO may...
Got my new rims and tires on, (2.5" back spacing) and things look real good. The tires stick out quite a bit, and stones are flinging very frequently. I looked on Ebay and the various J**p flares can be had reasonable as well the local bone yard may be even better.
Anyway, which year/model seem...
Thanks for all the replies! BUT
1.) Rebuilt the carb. Acid/carb (water based stuff) dipped it. Everything should be good.
2.) Cap is off the 66. (rigged under the left rear wheel well, fer now) The tank has a fuel filter (vent) hanging off the end of a 1/4" hose,.....for now till I get some...
I have just started to drive this thing as it's a project, near complete, therefore I can't comment on the parking on a hill issue. Typically, it gets run around on the road for an hour or so, then it's parked. The NEXT day, she'll spark right up, noting that the gas is JUST into the site glass...
This may be an old hashed over topic, but it's getting a bit frustrating for me. 66 Cruiser w/ 74 driveline.
If my Unit sits for about a week w/o running, the carb bowl goes almost dry, then its.......crankity, crankity. I have a stock set of lines till the filter area. Then I've got NEW lines...
As you're counting your pennies, go here and possibly save a couple! Note that they will let you swap in a different fuel gauge if your sender is already in.
Thought this was the best price I could find!
Have been doing some "Googling" around for an aftermarket application for a speedometer for my unit.
Was hoping that Sunpro had one but can't find one yet as they are very possibly going to be the gauge of choice, for me.
Any help appreciated.
I thought a while ago, someone posted a link to a "covered" toggle. The cover, in the down position will turn off the switch.
Another interest is a fuse block that you NEVER have to stop and jiggle fuse to make the gages work, or start charging, etc.
What donor vehicle block would work well...
Where EXACTLY is the back spacing measured? From the lip/edge of the rim to the back side of the rim (mating surface)?
Is the back spacing measured from the flat/shouldered area that rests against the tire bead, to the back side of the rim (mating surface)?
Am on the phone with Rick at 4 Wheel Parts, and he satates that on my 66/74 cruiser with drum brakes an Alloy rim that I want to purchase WILL rub my tie rod ends!
He says NONE of the Alloy rims have, what he recommends 2.5" back spacing, as the Steel wheels do.
I trust the experience of...
OK, I'm going to be a whiner.
Woody is very frim about the 3.5" back spacing, as well others have mentioned it, and I RESPECT THAT..........no question..........but;
The problem is I just got back from a Goodyear Dealer who sells rims & tires. There were NO listings of this back spacing in...