Recent content by got_mud

Need to find piece that holds the front signal lights, just below the grill. Fender should be repairable.

I was in a minor no fault fender bender with my 92 HJD81. Busted passenger headlight, scuff on fender flare, dimple on fender, warped valence under grill, scuffed bomber. ICBC wanted to wright off, $3400 damage. Aprasied vehicle at $2900. Took some time to convince then that they were idiots...

where can I find a spare tire swing out bearing/hinge? Building a bumper.

Hikers beach up gold creek is a nice spot. 5k in, easy hike to a nice swimming hole on the creek. Park at the Gold Creek lower falls lot and Take the East Canyon trail. Have had place to myself during the week, weekends see more pressure.

1992 HDJ81 air conditioner hasn't worked in years, now it's making a terrible noise (pulley bearings?) even when not turned on. Just wondering if you can delete the AC, and run without it. Or if ithe AC unit is the same as non diesel motors. If it's a pia or $$$$ to replace it, I wanna just get...

Ding ding ding........BC40 nailed it.....

Thank you, yikes $155 switch.....

Finally got it started, starter works just fine. Pretty sure it's not getting 24v to starter. Takes 10-12 turns of the key and starter will click click and finally slowly turn motor over. Thinking it's the relay. Once I got it started I drove it to EBI, and parked it there. I'll let Steve...

Hi all, happy new year. Bit of an issue with my 92 hdj81, could use some insight. Last couple weeks my truck was having problem starting. Starter would occasionally click but not turnover motor, after a few try's. It would eventually turnover but turned slowly and barley started.. I suspected...

http://www.bcsuperads.com/tools_For_Sale/C524A1187547P1/BIG_206_Lb_English_PETER_WRIGHT_Blacksmith_Anvil.aspx

Been searching for info on a 92 81 series brake parts. Are they the same as North American 80 series? Can any one help with part # for stock pads and rotors? Cheers B.

Thanks guys, Jason at Cruisin is hooking me up he's got them in stock for a hundred bucks. Cheers Brian

Can anyone point me in the right direction, in finding a heavy duty spindle for a rear swing out. I'm in Poco. Thanks. Cheers.

Try Big O Tire on Westwood Street in Poco. They have done it for me in the past

Looks good Mat.....can't wait to see your next project.:clap: Cheers Brian.