Recent content by CDFarmer

Thanks ARB777, I read your above post sometime ago, and took note- Alfredo just did my 97’ 80 (July 9, 2019). I couldn’t have been happier with the whole process. Factory Toyota seal, aftermarket glass, well versed with the FSM procedure (as noted) Alfredo’s Auto Glass 12847 Temescal Canyon Rd...

Sorry, slight hijack- FWIW- may shed some light on these Fox failures Years ago I had multiple failures (3 total) of the front, (US) passenger side, Old Man Emu LTR shock (LTR's were ARB's "so called" high end reservoir shocks) ARB came to the conclusion that the "premature" failures were caused...

Interesting on all the failure(s). I too had a front fail at >10,000 miles, 99% on-road use, just out of warranty- I reached out to Fox, they offered zero help. Sonny at Down South gave me a good deal on a replacement, though.... Curious if the front failures you both experienced were on the...

Hi pvalchev, Congradulations on your purchase- ALDL is behind ash tray (remove ashtray 2 screws) should see the connector, also accessible underneath ashtray. - I haven't driven the 40 since I sold it over 3 years ago, but I would routinely drive from sea level to 8,000ft without issue-...

For those interested- *500 mile report, mix around town/highway/16 miles graded dirt (Set-up F&R) 50mm Constant rate King Coils (AUS) + Fox 2.0 IFP 1" - 2.5" lift version 315 BFG KM2 36 psi (highway) 20 psi (dirt) Fairly light 80, ARB bullbar (no winch), Slee sliders, factory rear bumper, no...

Weekend bump for a very well built FJ40! I actually owned the sellers previous 40, (the sister FJ40 - to be exact) and can vouch for the quality of Robert's work! Chris (note: the seller has added a HFS front bumper & Warn 8274 since the pictures were taken)

Are you running a Toyota OE wire set - Denso plugs? As others have mentioned, aftermarket plug wires may be the culprit. Check the air intake boot for cracks. While the truck is running, see if you can duplicate the idle issue by moving the boot back and forth. If all else fails, see if you...

No- I've never touched the hose, 2.5" lift, 35" BFG muds w/ no bump stop spacer

Shock pictured is a 2.5" King 3 tube bypass w/ reservoir (not for 80, just for reference) Bypass are the "tubes" which allow fine tuning of the shocks compression and rebound characteristics Reservoirs allow for increased fluid capacity - cooler shocks basically, less chance of overheating...

Not a 4" or 6" lift, but gives you an idea of what a Light Racing Jounce shock looks like resting inside the front coil (850) of an 80- BTW, not my 80- I've seen two 80's setup this way, one with twin tube 2.5 Kings bypass shocks, 2" Downey coils, and Light Racing Jounce shocks front and rear...

Nice work Joe! Sounds like you guys had a great time...... Chris Sent from my iPad using IH8MUD

I would hope a US District Judge would know more about "due process" than me:) Especially one with more than 20 years on the bench! >>>interesting video of Phil Liggett's opinion on USADA (from 8/29) http://youtu.be/VJz4kwm9mXc

I think most people had already convicted Lance prior to his withdrawal from the USADA investigation. But just to be clear, there was never to be a "Trial". Lance was given the opportunity to testify, on his behalf, in regards to allegations (of doping) brought forth by USADA. USADA's...

I think the China remark was a joke! USADA spent $9 million in tax dollars to pursue this Witch hunt, and our country is in debt, with the largest foreign holder of U.S. debt being China, which owns more than $1.2 trillion in bills, notes and bonds, according to the US Treasury - so I think he's...

Cruiserparts.net has New Genuine Toyota "lefthand" drive quad light conversion kits - a bit spendy though $500+ Here is the link>> http://shop.cruiserparts.net/index.php?main_page=product_info&cPath=6_40_206&products_id=2461 You can also buy the 9005/9006 to H1/H4 conversion wire harness from...