Recent content by bikinnotdykin

bit of a dillema here. I have a built 350 carbed with rv cam and descent flowing heads probably just under 280 horse. Or I can use the L98 from my friends wrecked 1985 vette. I plan on using the stock toy 4 spd and running 33's with 4:10. this is not a daily driver or solely a wheeler, just a...

I am looking to buy a rear body channel from someone and was wondering how the cruiserparts.net ones were. since I need the front right cowl piece I was going to order both, but can't find a good description and their pics are too small to really see any detail. thanks guys and gals!!!

thanks gus, that's exactly what I was looking for!!

I saw someone once posted on here how they ordered the front kick vent panel and replaced it. well I need to do the same on the right side. if anyone knows where I can find a panel I only need the first 5 inches or so of where the panel meets the fender from the hood lip to the bottom. mine has...

I think that's worse than putting a ford engine into a chevy!!!! sell the jeep engines and buy the one you were looking at. or you can pick up a used 350 for around 500-1000 buckaroos.

pics?!!!

if it were me i would say "look it's a cruiser you can see the spot welds on the quarters from the factory". this thing is made to take you places not to be trailered to a car show!! get some scrap and pick up a welding book from barnes & noble and start reading. mig welding isn't hard and you...

what ever seats I use will have heaters, if I have to put them in or not fine. but when it's cold and you have heated seats it sure makes a difference. specially with the top off!!!! you can get them at jc whittney by the way

i have used mine for varius other jobs but not sheet yet. I will be using it for that soon though. I would get the smallest wire you can use without changing the sleeve in the cable to the gun. use gas, do not use gasless wire unless it's a last resort. and just set it on a low setting and...

you should be able to see the tack welds after you sand the corners down to metal, you may be able to see them from the underside looking back also. ccot has panels as well as some other venders.

nice stuff you have there!!!:cheers:

oh and it looks like I'll be able to get my setup around february so I'll be working on the steel tub untill then. man I wish I had a garage, I'll be using my friends pad again!!!!

ok I think I'm talked into putting an nv4500 in it. I found the whole kit with a spankin new tranny for 3500K does anyone know where I could possibly find a better deal?? the tranny itself is 2200K I thought about buying a used one but am wary from all the hopped up diesel trucks working the...

send it to chris angel!!!!

no, I'm not trying to do two at once I just couldn't pass up the last one I got for like 350 bucks and it is in way better shape. now I have the parts for 2 and will build the other one later on and make it more for the hardcore stuff. thanks for the input so far, let's hear some more. spend the...