You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
alia176
'96 80 series list of mods:
Dobinson 3" springs,
Ironman 4x4 Foam cell shocks,
DIY sliders, double as air tanks,
DIY rear bumper with tire swingout and fold down tray,
DIY rear LCA fortification,
DIY York mounting (first one on a 1FZFE in USA),
DIY laptop mount for Jotto Desk,
DIY rear cargo drawers
DIY front+rear panhard rod adjustors from Slee
DIY exh manifold food warmer
DIY mandrel bent up/over 2.5" exhaust
Warn M10,000# winch + air tank inside front ARB bumper
ARB front+rear air lockers using factory locker selector switch
Yaesu FT-8800 HAM radio with custom remote head mount above rearview mirror
Slee rear UCAs adj
Slee caster plates
Slee blue bushings througout except the rear end of front radius arms.
Slee Tcase skid plate (smaller one, not the huge one)
Wrangler NW power products dual batt system
4:56 R&P ratio (did them when I was living at sea level but not good at elevations)
T-case part time and 3:1 Marks low range gear set
Aisin front lockout hubs
OEM front+rear axles and birfs
Helton water heater, Blue color unit
On board shower
OEM aux subtank + TaskLED ECU for transferring fuel
Infinity Basslink + pioneer speakers + Sony HU
Cobra CB radio inside 2nd DIN slot
All LED lights from TaskLED
Nitto TG 315 75 16s
Work light on rear spoilder VisionX single pod connected to a manual switch or auto on with reverse lights
Trailer connector 7 pin RV style blade
Milford cargo barrier
Work performed
Head Gasket
starter rebuild, few times
miles of wiring for power outlets
TIG welded up the crack on exh downpipe at crotch
Schaffer lubricant in both diffs + Tcase
2003 4Runner Sport V8
DIY sliders that hold air
DIY install of Air Zenith air comp + aux fuse block + dash push button
2" icon shocks + springs in the rear
Bilstein 6112s up front set for 1.5" lift
Front LCA bushings + BJs by Moog
DIY rear LCA fortfications against bending
LED warm white under hood and upper rear tailgate
Swapped out the hood with a non hood scoop, same color
Gibson SS cat back exhaust
Falken Wilpeak AT3 265 70 17s with minor rubbing on turns