Is 4x4Labs still making there high steer stuff. I love my setup. Any large pattern knuckle high steer arms would bolt on six shooters also where available at one time. . I’m not sure about them anymore either. I’m out of the loop these days lol.
Most fork lifts of seen had the 2F
I have the Toyota forklift parts Catalog EPC. I’ll see if I can fire up my old windows XP machine and I snoop around and see what part numbers show up for the F and see what uesrs they used the F in. Maybe...
Those little Bluetooth amps inside that housing are tiny hard to believe it pumps out some decent volume. They sell for like $25 bucks for the unit. Too bad no info on the channels the ohms of speakers used and the voltage required to get that...
Here’s some rigs from Kelowna home of Aqualu. I know fsr from stock. The ICON also is all Aqualu. Pics for fun of some Kelowna rigs.
A 4 wheeling group called Kelowna Snow Wheelers
Small highjack. lol there rigs seem to survive Canadian...
Aqualu have sold tons of tubs. All marine grade aluminum great products.i live about 4 hrs away from them. Tons of there bodies running around here. Winter salt gravel on the roads. Never hear of any issues.
There was someone offering a kit with a single shock in the middle of the hood it looked real nice. Came off the firewall to the Center of the hood but I think his was a split hood and it bolted to the Center rib.
I wouldn’t think it would go up to much. Could ask them if they can ship UPS Worldwide Expedited that will give ya the final total. No surprises before you even pull the trigger
I get most of my stuff dropped shipped to an address in Blane...
For me in the end I just removed that valve it started to dribble and i ran the hoses straight to the heater core it made for a nice clean install haven’t had issues in the past10 years roof off so don’t notice any extra in cab heat in the summer
Will have to search here on mud lots of talk on this. Not all gears mate to the drive gear. There are 4 plastic gears and two metal drive gears. One drive gear I think mates to 16,17,19 the other one only to 18. Im just guessing been a long...
I adjust mine with the engine running in neutral and the clutch cover removed to see what's going on.
Play with the extension of the slave cylinder shaft so it spins the throwout bearing then back off until it doesn't spin it anymore, then get...
I post that two comments above about alignment. Yep. At least ya figures it out. I’ve messed with these V8 conversion clutch issues for years. Adjust the pedal play at the master to almost zero tolerance. Make sure your clutch pedal isn’t...
If it was the hub in the clutch disc that has wallowed itself loose and is wobbly it is an alignment issue. Been there done that. Check bellhousing fit to engine. Flush. And then fit bellhousing to Tranny. Mine had a dowel pin to long and was...
This week: Mostly driving to the office, so far good as a daily driver! This weekend my wife was on a girls trip, so I took the kiddos out with a buddy of mine for an easy trail (Johnny Park road), lots of breaks & a few hikes. Kids had a blast!