BigSwede

Worth watching, but the OP is only talking about a 2" lift. Not much of a concern.

With my at wife at 5'-1", God bless seat memory!

As far as it goes. IIRC I get about a 75" bed. Fortunately with seat memory it is easy to return it to where it was, in the morning.

I am a fan of this idea. I built my own platform out of 20/20 aluminum and it didn't cost anything close to $600. But it works well, I am 6'2" and can lay straight out if I want to, with my head against the drivers seat back...

Install errors maybe? Or not, I dunno. I've had it on there 3 years now and maybe 35k miles. I would think my fairly hard wheeling with a 35 on the carrier would test it pretty well.

Still going strong. Some powder coat has come off of the license plate holder, and will need repainting. It is worth noting that my GX is a dedicated off road truck, meaning I don't drive it in the road salt much. I think if I did, I would need...

FWIW the SPC UCAs for the GX460 are single castings, I don't think there are any welds.

I replaced mine a couple years ago, looks like they changed them since then.

You can also post as PUBLIC, Unlisted and share the link. I do that often for family.

You can use youtube and set videos to invite only and share the link

Can videos be inserted into a post? Guessing you have to link to it but I don't have them hosted anywhere.

I have experience with ARB lockers from previous vehicles 10-20 years ago. I did have to pull the third members a couple of times to replace the seals, which is a PITA that an electric locker won't have. These days I have a rear Eaton e-locker...

Wheeler Lake was amazing! Two of the Jeeps in our group flopped. I was the only non Jeep. And one of only two that didnt have to winch.

Prepairing for a long trip to Montana this morning, while removing my front skid plate for an oil change a large bolt dropped on the ground. A bit confused I start to look and the area the alignment shop would have been working the day before as...