Test assembly.
The shroud covers the battery on three sides and is held off the battery by two rows of 3/8” foam to allow venting. A thermo switch (40 C on/30 C off) switches the ground side of the avionics blower which is mounted to the...
@gluaisrothai the warmest I've seen the DCS lithium under hood was 64c/147f per the BMS temp sensor, last summer in a long up hill climb. OAT was around 95.
It's mounted on the front left.
Hello everybody ;-)
It hasn’t been a week, exactly but I’ve just collected my car from the wrapper last night and put on the new tyres today.
- satin wrap, dual colour
- alloys renovated and powder coated in satin black
- rear “LC” decor, rear...
@NITC thank you 😇 the aux battery was not grounded rookie move on behalf. Once I had a proper ground flashing stopped and all lights are now solid. Thank you all for your help and support. Just finished wrapping everything up and putting...
You'll want to check right at the BCDC by probing the red wire. Testing at the starter battery won't tell you the voltage reaching the BCDC. I ran into this a while back and found a bad cable/connector like this
Also you can ground the blue wire...
What is the voltage coming in on the red wire from the starter battery?
It best to probe the wire to message the voltage as close to the bcdc as possible.
I also rotate all 5 tires every 5,000 miles using the Rearward Cross protocol recommended by Tire Rack:
This not only evens out Front/Rear and Left/Right wear patterns for all tires, but assures that my spare is the same diameter as the other...
Out in the middle of nowhere (Anza Borrego) and got an unexpected airshow for the better part of an hour. Both Thunderbirds and Blue Angels were training and possibly using our group as a landmark.