Windshield Rubber - 1967 FJ40

[brooklyn]

Called Cruiser Dan today to see if he had a windshield gasket for my 1967 FJ40. He doesn't have a part book for that year - only goes back to 1969. Anyway, he said the '69 used a two part system (part number 56121-60001 and 50122-60011).

Anyone know if this will work for a '67? Are the windshields that different from the later model years?

Any help is appreciated.
Joe

 

[Dusty 66]

Early years are shoter, Late 65 to thru 74 are same you will be good then. 74 on are bit wider

 

[pappy]

I just did this on my 1969. Spector shows 1965-1974 as the same. The gasket is one piece, but there is a narrow "key" that goes on the front side after the glass is installed.

 

[brooklyn]

A narrow key? Is this a insert that goes into the gasket?

 

[pappy]

Yes. #3 in this SOR drawing is the gasket, #4 is the key.

 

[albee]

They sell the exact same gasket and key at my local glass shop for about .25 per foot. They use it for tractors.
Good luck Albee

 

[Dusty 66]

It's not a molded like the OEM, to the fram one piece with a rubber key ?

rather a cut to fit rubber gasket with a key ?

Would like to see...

 

[Dusty 66]

A narrow key? Is this a insert that goes into the gasket?

Its about 1/4" wide and about 8" longer than is needed cut to fit a special glasers tool & windex works perfactly

 

[brooklyn]

'69 Gasket From CDAN

Thanks for all the info...I talked to CDAN and he was able to get me the gaskets (2 parts as described above). OEM, so I am hoping this will be an easy fix.