macneill
Rollin’ on 33s
I picked up set of used PIAA 520s (thanks uzj100) and I can't decide/figure out where to put them on the bull bar.
Seems the bar was well designed with approach angle in mind and doesn't leave a lot of extra space for non protruding brackets.
I don't want them sticking out too far so they get crushed.
I'm open to welding a few angle tabs on, or some half circles cut in flat stock to fit on the tubular part.
The top of the bar is out of the question. My wife's adamently against that.
Oh, and those two vertical rod racks are not on right now.
Any thoughts?
Seems the bar was well designed with approach angle in mind and doesn't leave a lot of extra space for non protruding brackets.
I don't want them sticking out too far so they get crushed.
I'm open to welding a few angle tabs on, or some half circles cut in flat stock to fit on the tubular part.
The top of the bar is out of the question. My wife's adamently against that.
Oh, and those two vertical rod racks are not on right now.
Any thoughts?
Last edited: