Wheels on the ground, finally, test drive tomorrow night.
What are you working on? (11 Viewers)
- Thread starter matzell
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #542
Lets get that thing to Relic Run next week!
That's definitely the plan!
- Thread starter
- #544
Got the new club banner. 5x5
3 test drives done, so far so good.
Land Shark
SILVER Star
Too much to ask you to bring to meeting tomorrow?
- Thread starter
- #547
It is in the 80!
Land Shark
SILVER Star
This has me thinking. What would a small flag size run me? Say 18x24
- Thread starter
- #549
We can dicuss at the meeting...
davidp14
SILVER Star
Like it never happened. ... I'll probably leave the seats out for a while, or at least one of them.
Land Shark
SILVER Star
That's beautiful man!
- Thread starter
- #552
And here I was looking in the bucket of the tractor for something cool!! No it looks good and happy to help out with it.
davidp14
SILVER Star
Sorry. Local traffic is heavy this time of year.
Thanks again, Rob.
I put these in today too:
Thanks again, Rob.
I put these in today too:
Can someone with a 80 and a temperature gun do me favor, after driving on highway a solid 30 to 45 minutes take a temperature reading on you rear hubs. Specially end of your rear axle shaft. I'm reading 120*f +/- 10* after driving 30+minutes. I have loosened up my parking brake adjustment. The drum is reading 170*+ .
- Thread starter
- #555
Got power... I like this usb port with volt gauge. I can turn the whole switch on/off if needed. Of course 12v plug is the other one.
Next time I drive mine I’ll do that for you
- Thread starter
- #557
Finally getting my little one ready. Installed some new Pro Comp rear springs to replace the clapped out Ranchos. I gained ~2" of lift and moved the reat axle back another 3/8". I also installed a set of Marks Off Road shackles for more travel and a slight more lift. @65swb45 I hope to clear the rear inner fender a little better.
- Thread starter
- #558
No words needed...
- Thread starter
- #559
Peeled all the linex off
Trail Taylor brake backing plate installation, definitely needed additional coats of paint, only one slight difference that I'm pointing to in picture. Overall not a bad replacement. They did send me two for the right rear instead of right and left rear. Definitely is centered on my hub better than my old one. Everything is back together, test drive in morning to see if this helps with hub temp issue. I did take some measurements, spindle does not appear to be bent.