turn signal question (1 Viewer)

[76 PTO]

Ok guys this is another turnsignal flasher question. I put led turn signals up front, and they do not flash when the turnsignal is on. I know I need a electronic flasher, but they do flash when the hazards are on. They also will not work when the lights are on. The leds came with 2 pos. leads and a ground , one with a resistor on it and one with a transistor on it. I was told from a guy at work that the one with the resitor would be for the running lights. The resistor is I think 360 OHMS. Why would they flash with the hazard but not with the turnsignal switch?

 

[Gusb]

Check your grounds - especially around the fender mounts.

 

[76 PTO]

The two wires from the harness running lights and then turnsignals??

 

[PhrogsPhorever]

The two wires from the harness running lights and then turnsignals??

Yep. Two positive leads (Green for parking and GY/GB for T/S) and it grounds to the fender thru the big assed bolt. I had the same problems, I ran leads from the T/S to the grounds I have my horns hooked up to, and all the problems went away

 

[Pin_Head]

Why would they flash with the hazard but not with the turnsignal switch?

The original flasher is load sensitive and needs a certain amount of watts to heat up the bimetal switch. With the hazards there are 4 bulbs lighting up instead of 2 and this is enough load to trip the flasher. Get an electronic flasher that is not load sensitive.

 

[76 PTO]

thats what I thought , thanks