Todays wrenching (1 Viewer)

[remy1974]

Putting her back together for cmcc

 

[NeverGiveUpYota]

Putting her back together for cmcc View attachment 2008458View attachment 2008459View attachment 2008458View attachment 2008459

Is that Bessy (whatever her name was)! What happened to the 87 w/ the 5 speed?

 

[remy1974]

Put carb back on it fresh battery fresh brakes on the rear end hopefully back in this weekend and need to drain the 4 yr old gas for some new once I got fuel to the carb she kicked right over and purredlike a kitten

 

[remy1974]

Ole sweet bessy, the other is on back burner little longer

 

[remy1974]

 

[remy1974]

I think she’s got another season in her lol as long as I stop doing burnouts with it at least with my 35s on it

 

[shmukster]

Looking forward to seeing you at coal mine!!!!!

 

[remy1974]

Can’t wait I need a break this is the busiest I’ve seen it at work in a long time just need to find a tow rig the guy who’s truck I used to borrow retired and sold his truck

 

[remy1974]

 

[remy1974]

Still need to bleed and adjust the brakes new rear shocks, check the fluids, put some fresh gas in her register it and road test

 

[NeverGiveUpYota]

Still need to bleed and adjust the brakes new rear shocks, check the fluids, put some fresh gas in her register it and road test

Love the Rausch Creek sticker.

 

[Cruiser_Nerd]

Love the lift.....that's what I need for cleaning the bottom of the trucks.

 

[remy1974]

Lol lot easier getting it off trailer with out an axle under it plus the scale of the crane said it weighed 4800 lbs

 

[plfj40]

The bred trick works great.

 

[NeverGiveUpYota]

The bred trick works great.

View attachment 2023376

View attachment 2023377

View attachment 2023378

View attachment 2023379

I tried newspaper. Didn’t work at all so I rented the puller and slide hammer from Napa. Darn jaws were too big so I trimmed them down where they mated together and now own it (not the slide hammer part).

 

[plfj40]

I tried newspaper. Didn’t work at all so I rented the puller and slide hammer from Napa. Darn jaws were too big so I trimmed them down where they mated together and now own it (not the slide hammer part).

View attachment 2023398

View attachment 2023399

It was easiest bearing i ever did. Even did 2 engines in 5 minutes with same bread piece.

 

[yodafrick]

The bred trick works great.

View attachment 2023376

View attachment 2023377

View attachment 2023378

View attachment 2023379

Yup, best cleanest way. And a snack for after.

 

[NeverGiveUpYota]

Next time I’ll waste my bread.

My 2F is out of my hands now... pending quote on cleaning, overbore, honing, possibly ridge rheaming, grind and polish cam and crank if they warrant good, inspect and same to main bearing caps and connecting rods, pressing new can bearings, add new freeze plugs, machine flywheel. Fingers crossed. I plan to assemble at home w/ my son if doing it together doesn’t prove to make my head explode.

 

[remy1974]

Apparently the trailer needed a little love to make it to cmcc

 

[remy1974]

The saying of just one more trip wasn’t in the cards