Still loving it. I think it goes well with RW and BFG KO2s. No lights yet bit thinking about it. Don't want to over do it
TJM Push Guard
- Thread starter slaquer5
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
To take the grill off:
1. Take the top cover off by pushing in small button on each of the plastic retainers then theythe can be pulled up with fingers. Cover comes of in 1-2min
2. Unscrew 3 zcrews from top edge of the grill wgich was covered by cover. 1min
3. Probable the most difficult part is tho remove the grill. Now it is retained by plastic clips. Look inside and you will see how they are aligned and work. I pushed them in the correct direction and grill comes of forward. Drivers side is easy as u can see all the clips. On passenger side they are in the same spot but obscured by some kind of air intake. However i was able to pushh them with a finger/screwdriver. Took me 30 min. To do it 2nd time 5 min
4. Grill goes forward but limited by wire sttetch to the camera. I did not disconnect it. It was enough to insert the brackets and drill 2 holes.
5. Lower brackets should take 15 min. But took me around 30 due to left/right labeling confusion. You have my photo of it so it is straight forward.
1. Take the top cover off by pushing in small button on each of the plastic retainers then theythe can be pulled up with fingers. Cover comes of in 1-2min
2. Unscrew 3 zcrews from top edge of the grill wgich was covered by cover. 1min
3. Probable the most difficult part is tho remove the grill. Now it is retained by plastic clips. Look inside and you will see how they are aligned and work. I pushed them in the correct direction and grill comes of forward. Drivers side is easy as u can see all the clips. On passenger side they are in the same spot but obscured by some kind of air intake. However i was able to pushh them with a finger/screwdriver. Took me 30 min. To do it 2nd time 5 min
4. Grill goes forward but limited by wire sttetch to the camera. I did not disconnect it. It was enough to insert the brackets and drill 2 holes.
5. Lower brackets should take 15 min. But took me around 30 due to left/right labeling confusion. You have my photo of it so it is straight forward.
Typing from my phone...
Awesome! Hope it works out easy. I would love to see the headlights instalation and finish looks
Great work! Looking nice! Would you comment on camera and radar function? Also how did you mount and wire up the lights?
- Thread starter
- #33
The camera is partially blocked by my bar and lights. I am not sure about the radar . How would I know ? I am not getting any warning light about radar being blocked .
I did not have time to wire up the lights . I also might put a smaller set of light on it also down on the plate.
I did not have time to wire up the lights . I also might put a smaller set of light on it also down on the plate.
Thanks for reply. I guess the cruise control would not work. When i get too much snow or rain covering "toyota emblem" i get the light warning and cruise doesn't work.
- Thread starter
- #35
When I get home I will try the cruise control .
I am not sure if 2 sets of lights would be to many lights .
No such thing as too many lights
- Thread starter
- #37
No such thing as too many lights
I am hoping your right. I am going to try and find some small rectangle light to go over the bottom plate on the bar .
I just wanted to say your bull bar looks pretty bad a$$, especially the black!
- Thread starter
- #39
Thanks brother
- Thread starter
- #40
Ok I tried out the radar and the radar works fine. The camera has some clutter.
I will post a picture of the front view camera
