Swap from electronic throttle to cable - 2UZ?
- Thread starter woytovich
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Haven't been down this path. I would guess the A750F is being controlled differently by wire than the A343F is controlled by cable? Might be your work around challenge...dunno.
The ECU is going to see problems since the throttle position sensor and the pedal position sensor work in tandem for both EFI function and transmission shift point functions.
It's been done on other toyota vehicles with success. The LC100 should be similar enough that you can use some of the same techniques. Try the info in this link - http://my.is/forums/f114/bypassing-dbw-stock-parts-325195/
- Thread starter
- #5
Onur.
1. Missed you at CMCC
2. Re this mod: Can't I swap in the whole shebang from a cable pedal in place of the whole set-up from an electronic pedal...? And by "whole shebang" I mean everything from the cable onward that makes it work...
3. Do you have pictures/diagrams of these 2 flavors of pedal>throttle body?
1. Missed you at CMCC
2. Re this mod: Can't I swap in the whole shebang from a cable pedal in place of the whole set-up from an electronic pedal...? And by "whole shebang" I mean everything from the cable onward that makes it work...
3. Do you have pictures/diagrams of these 2 flavors of pedal>throttle body?
- Thread starter
- #6
1. I'm not talking about the cable to the ttansmission anyway, I'm talking about the cable from the gas pedal to the throttle body.
2. And I'm not going to be using the auto transmission anyway....
- Thread starter
- #7
Bump... I'm FINALLY getting to this project. I have the cable TB bolted up (ish) and need help with the wires and hose connections - they are different between the 2. Pics/FSM images of a cable TB labeled would be helpful...
Mark
Mark
