Hey guys,
I have just got myself some 255/85r16 KM2s for my 60 series split rims.
I have mounted the tyres back onto the rims and have the ring seated properly, with the split opposite of the valve.
Just when I pump them up, the bead does not seem to seat where the valve is. The bead seats fine on the entire back side of the rim, and all around the front just not where the valve is, and you can see the tyre wall inside the little valve hole on the rim.
Do I just need to pump them up some more? I went to about 35psi.
I have mounted up two tyres so far and have the exact same problem on each. Plenty of talcum powder and soapy water used too.
Any ideas?
Can get pictures if I dont make sense,
Cheers
Ben
I have just got myself some 255/85r16 KM2s for my 60 series split rims.
I have mounted the tyres back onto the rims and have the ring seated properly, with the split opposite of the valve.
Just when I pump them up, the bead does not seem to seat where the valve is. The bead seats fine on the entire back side of the rim, and all around the front just not where the valve is, and you can see the tyre wall inside the little valve hole on the rim.
Do I just need to pump them up some more? I went to about 35psi.
I have mounted up two tyres so far and have the exact same problem on each. Plenty of talcum powder and soapy water used too.
Any ideas?
Can get pictures if I dont make sense,
Cheers
Ben