- Location
- United States
Replaced my home brew exhaust with a fancy stainless EMSPowered System, so, this is taking up space.
About three years ago I cut up a set of fresh MAF fj62 down pipes and made a nice y-pipe and eliminated the under frame, rock catching exhaust pipe.
Eliminated the cats but retained the o2 sensor bungs.
Flow master Muffler
2.5" pipe straight over the rear axle and out the back.
Sounds fine, certainly better than a leaking stock system.
It drones getting up to speed, but once on the highway in over drive, it is tolerable.
I did cut it on strait sections in order to remove it from the truck. Could be band clamped back together, or welded.
The down pipe and y-pipe are the only real value here, the rest you could use or have an exhaust shop fab.
No manifolds, o2 sensors, clamps or gaskets included.
$350 + Shipping. Make offers.
PayPal encouraged.
Come pick it up in South Philadelphia if you like.
High and tight:
All boxed up and ready to ship.
About three years ago I cut up a set of fresh MAF fj62 down pipes and made a nice y-pipe and eliminated the under frame, rock catching exhaust pipe.
Eliminated the cats but retained the o2 sensor bungs.
Flow master Muffler
2.5" pipe straight over the rear axle and out the back.
Sounds fine, certainly better than a leaking stock system.
It drones getting up to speed, but once on the highway in over drive, it is tolerable.
I did cut it on strait sections in order to remove it from the truck. Could be band clamped back together, or welded.
The down pipe and y-pipe are the only real value here, the rest you could use or have an exhaust shop fab.
No manifolds, o2 sensors, clamps or gaskets included.
$350 + Shipping. Make offers.
PayPal encouraged.
Come pick it up in South Philadelphia if you like.
High and tight:
All boxed up and ready to ship.