So whens the next "tech day" get together? (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 25, 2005
Threads
146
Messages
1,857
Location
Prescott Valley, AZ
I know I have to get back into my front axle and replace the axle tube seal on my rig.

Do we have anything planned for tech days comin up around here or PHX?
 
My driveway this morning. Power steering pump and lines. Also someone elses rear control arms need to be un-taco'd. There will be wrenching and drinking starting shortly.
 
ill be there in spirit:beer:
 
power steering - check
new alternator - check
reinforced arms - check

it was a good day. alvin, ross, thanks for the help!
:cheers:
 
I need to do the same (replace a seal) and a new cruiser buddy 4 houses down the street is going to do his birf job at my place...you are welcome to join, although I don't know the date yet.
 
power steering - check
new alternator - check
reinforced arms - check

it was a good day. alvin, ross, thanks for the help!
:cheers:

Power steering - fixed
new alternator - installed
bearing on idler pulley - shot, needs to be replaced, makes nasty knocking noise, embarrassing. I'm gonna yank it back out tomorrow until I get a new bearing for it.

Glad to help on your rear arms. That one was bent with a capitol F.
 
...

Glad to help on your rear arms. That one was bent with a capitol F.

So, did you replace or do the smash straight and smoke wrench thing?:hillbilly:
 
So, did you replace or do the smash straight and smoke wrench thing?:hillbilly:

we took the $45 option:grinpimp:
IMG_0343.jpg
IMG_0344.jpg
 
Tried to drive over them to straighten. Didn't work. Put them in my press, got them mostly straight, then welded angle iron to them. They're pretty straight now, and beefed up.

Just an observation, the stock rear lowers on the 95 were no where near as beefy as the ones that were on my 94 and Ross' 94.
 

Users who are viewing this thread

Back
Top Bottom