sliders on bj7x cruisers

[blurr1604]

hey guys, was hoping some of you out there with the BJ7x's could post some pics of your slider setups, i'm after some ideas for the brackets to the chassis as the exhaust on mine, and most i have seen, runs along the outside of the chassis rail, so traditional chassis clamp cant really be done ? been offered by a mate to make them up cheap, so was just after some ideas,

my cruiser is a BJ71,

cheers,
blair

 

[Thommo 73]

cant find a photo of the mounts but it hast the pipe on the rh out side of the chassis but i still used the u channel to mount. front was mounted off the cross member bolts

 

[BeratE]

Looks nice. Got any other pics?

Oh yeah, and he was probably most interested in the other side of the truck

 

[lulo]

Looks nice. Got any other pics?

...x2

 

[Clint79]

mint a troopy with rear flares i love that look

 

[blurr1604]

anyone got pics of the brackets to the chassis where the exhaust runs?????

 

[boogie74]

You could try Cheezy Racing. I've seen there stuff on a GQ but not sure if they make
cruiser stuff. Good quality and solid. Maybe find a mate who can weld

 

[blurr1604]

You could try Cheezy Racing. I've seen there stuff on a GQ but not sure if they make
cruiser stuff. Good quality and solid. Maybe find a mate who can weld

wouldnt go them, they are over east and cost the earth, got a guy who can fab it up, was just curious as to how to mount it, oh well

 

[Thommo 73]

cant find any more photo's (not mine, i just made them for him)

but i used 50 x 50mm angle bolted to the front two bolts of the GB x member then welded bent pipe to support the main rail.

the middle and rear supports are standard U brakets .

it was very close to the exhaust but with 5mm of spacers under the exhaust rubbers it has about 12-15mm of clearance.

 

[lshobie]

Run the exhaust on the inside of the frame rail between the transfer case and the frame rail - don't run it up and over the frame rail - then you can build the sliders properly.

 

[blurr1604]

Run the exhaust on the inside of the frame rail between the transfer case and the frame rail - don't run it up and over the frame rail - then you can build the sliders properly.

thats what i thought $$$$, didnt want it to be the case though was hoping someone would have a brilliant and bright idea

 

[bj70_guy]

These are the ones jason (Cruisin' here on Mud) built for my BJ74:

 

[blurr1604]

thats what i was after, thanks a lot mate

 

[lulo]

Nice Sliders...

 

[Gib009]

great looking sliders. Any chance of pics with them mounted?

 

[bj70_guy]

sure: