searched pinoin angles but can't find what I want

[Freakshow]

I'm about 1000 miles from my cruisier so I can't just measure what
I need (I hate being a trucker some days). I've got Diamond axles
building me a 9" D60 outter housing for my rig and they need some
#'s.

I'm flipping the front springs and a soa. what will the spring * be?
I've got 2* in my head but not sure.

My fj has a 350 infront of a cruiser 4 speed and TC, but I'm swapping
in a 700r4 and d300, if I'm thinking right they will be about the same
length, so will 13* pinion angle be about right?


Flame on boys! I'm paying 25 cents a minute to be on this damned internet
coin operated piece of crap so I gotts to go!

 

[FJ40fiji]

There are too many variables in this to be sure. You'd really be best off IMO to have the axle guys hold off until you do the other stuff and then measure it. Or tell them not to weld up the perches or knuckles (if they are building a front), and you can do that or have it done locally when you have it set where you want it.

 

[Adventure Teq]

Yup, kind of hard just guessing, I wouldn't guess if I were shelling out that kind of money for a custom built axle. Need to have the rig at the shop or at least take the axle home and figure your numbers then take it back for finishing up.