Scangauge for transmission temperature here you go !

[half k cruiser]

For those of you running the scangauge II with X-gauge are you able to program in to get your transmission temperatures ? If so what codes are you using and are you switching the program from ISO over to CANSF ?

Edit: this is on an 04

 

[half k cruiser]

Answered my own question. My Scangauge is reading ISO on my 04 GX. If yours reads ISO (should be 03-04 rigs) then you can use the following code to get feedback from your transmission sensor.

TXD: 686AF101B4

RXF: 044105B40000

RXD: 2808

MTH: 00090005FFD8

I will test it out some more as I just got it going out in the driveway. Current trans temp was 167* sitting.

If you are running in CANSF (should be 05+ rigs) then you might give the following code a try.

TXD: 07E021D9

RXF: 032180000000

RXD: 2810

MTH: 00070064FE70

Enjoy !

 

[danthemanx07]

I am not sure which code I am using but I have my Scangauge set up to display TFT on my 2005. Works great.

NOTE - you must have the latest firmware version for the gauge to work though. I had to send mine in for an update before the gauge would work.

 

[half k cruiser]

I am not sure which code I am using but I have my Scangauge set up to display TFT on my 2005. Works great.

NOTE - you must have the latest firmware version for the gauge to work though. I had to send mine in for an update before the gauge would work.

Correct, I think they are on version 4.46. If you find the code you are running and its different then what I posted above please post up and we will add it to the list.