Rear Drive Shaft Double Cardan Cracked

[gnob]

I think the confusion is that Marlin is sending a front cv and op needs the rear cv.
I assume this shaft is the rear half of the rear ds?

 

[meatloaf]

Thanks gnob, let me ask him and I will update this post

 

[meatloaf]

I replied back to them asking whether it was a front or rear part, here's the reply
reply

 

[meatloaf]

Does anybody have the measurements for the center to center spacing for the bolt holes? I used a cheap digital Harbor Freight caliper to measure mine

 

[gnob]

I would have them sent a flange if it will work. The cv Marlin shows is way more readily available than any others.

 

[meatloaf]

I would have them sent a flange if it will work. The cv Marlin shows is way more readily available than any others.

Are the number of splines the same on both flanges?

 

[gnob]

I cant really say. Goid question for Marlin. You could also redrill yours to match

 

[meatloaf]

I ended up buying a couple of Moog 513 U-joints and swapping out the good part from Marlin. IT was a nightmare but got it done. Took the truck on a 200 mile drive, all good

 

[gnob]

Awesome. Way to adapt and overcome.