RCV 300m rear axle shaft- gap between snap ring hub (1 Viewer)

[2000cruiser]

Anyone install an RCV rear axle shaft and notice the larger than normal gap between the hub and snap ring? Can I roll with this? This is my passenger side…

 

[slow95z]

I just had an issue with RCV shafts being the wrong length.

Not sure on your exact issue but mine were about 4 inches too short.

 

[2000cruiser]

Mine was a hair less than 1/8 of an inch short. Negligible but it looks like that 8th is on this side . It surprisingly snapped in pretty solid, just concerned about the wear on the hub side. Did they require you to send it back? What was the turn around?