Does anyone know the size of the O-rings used in the 60/70 (and probably 40) series PTO boxes?
There are two sizes - one for the input gear shaft and lever shaft (3 in total) and one that lives inside the case where the shift shaft comes out of the front of the unit.
Unfortunately they are both 'flattened' slightly in cross section, so hard to match to a specific size. I think the larger one is non metric, BS114 but can't be sure. The smaller one is more distorted, possibly BS112.
NLA from Toyota.
Thanks
EO
There are two sizes - one for the input gear shaft and lever shaft (3 in total) and one that lives inside the case where the shift shaft comes out of the front of the unit.
Unfortunately they are both 'flattened' slightly in cross section, so hard to match to a specific size. I think the larger one is non metric, BS114 but can't be sure. The smaller one is more distorted, possibly BS112.
NLA from Toyota.
Thanks
EO