I have a 72 fj40 is there a bracket out there for the steering pump or do I have to make one? Also what about a double pulley to run a seperate belt for the pump? I'm new at this help would be very appreciated.
power steering conversion
- Thread starter fjpotter
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
https://forum.ih8mud.com/40-55-seri...uestions-***-f-q-***-updated-13-aug-08-a.html
here's a link to the frequently asked questions. scroll down a bit and you'll find several more links all about power steering conversions and what people have done.
the short answer to your question is yes. several aftermarket vendors make a pump bracket and i'm pretty sure there's a solution or two for the pulley also.
welcome to mud
(standard mud welcome) and post up some pics of that ride.
here's a link to the frequently asked questions. scroll down a bit and you'll find several more links all about power steering conversions and what people have done.
the short answer to your question is yes. several aftermarket vendors make a pump bracket and i'm pretty sure there's a solution or two for the pulley also.
welcome to mud
(standard mud welcome) and post up some pics of that ride.
pump bracket
Specter Off-Road-Land Cruiser Parts - 100-946-Power Steering Pump Bracket
MAF 4+Plus Saginaw Pump Bracket for 2F Engines
Saginaw Power Steering Pump Mount Land Cruiser 1F & 2F - JTOutfitters
these are for a saginaw setup. some people run these pumps with the minitruck setup, but most don't reccomend it if your running larger than stock tires. a sag box on the front frame rail will work better with bigger tires. there's a grainger part number somewhere for the correct width pulley. use the search function in the upper righthand corner and you can pretty much find anything. good luck.
Specter Off-Road-Land Cruiser Parts - 100-946-Power Steering Pump Bracket
MAF 4+Plus Saginaw Pump Bracket for 2F Engines
Saginaw Power Steering Pump Mount Land Cruiser 1F & 2F - JTOutfitters
these are for a saginaw setup. some people run these pumps with the minitruck setup, but most don't reccomend it if your running larger than stock tires. a sag box on the front frame rail will work better with bigger tires. there's a grainger part number somewhere for the correct width pulley. use the search function in the upper righthand corner and you can pretty much find anything. good luck.
- Thread starter
- #4
Thanks
Welcome fjpotter.
Missipboy is pointing you in the right direction. Do all the reading you can in the F.A.Q. section, then do a search on P.S. conversions. You can also pick up mucho information on vendor web sites. Good luck!
Missipboy is pointing you in the right direction. Do all the reading you can in the F.A.Q. section, then do a search on P.S. conversions. You can also pick up mucho information on vendor web sites. Good luck!
