possible JDM Aux A/C Fan wiring solution?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I just picked up a JDM from a local part-out, but he didn't have any of the wiring, just the fan itself. Did SOR have the male plug and wiring? i'm trying to stay as OEM as possible and Sumo's write-ups are a little over my head.

Did you ever figure out the male end part number or specifically where to buy the male end? I'm installing my fan through my SwitchPros so all the additional, wiring to the fuse and relay aren't needed by me. Just want the factory male connector.
 
Did you ever figure out the male end part number or specifically where to buy the male end? I'm installing my fan through my SwitchPros so all the additional, wiring to the fuse and relay aren't needed by me. Just want the factory male connector.
I believe second gen 4runners have a different fan, but the same wiring. I ended up snagging the connector while digging around at a junkyard for something else. I might be able to dig up a part number for you. I think it was a 95 that I got it out of.
 
I believe second gen 4runners have a different fan, but the same wiring. I ended up snagging the connector while digging around at a junkyard for something else. I might be able to dig up a part number for you. I think it was a 95 that I got it out of.
Our junkyards are wiped clean of most Toyota parts rapidly.

I think @Onur stated the connector is not available new.
 
Our junkyards are wiped clean of most Toyota parts rapidly.

I think @Onur stated the connector is not available new.
Our junkyards are too. When I came across this 4runner I was there for something else. Saw the fan and figured it was worth a shot. It ended up paying off. I'll keep an eye out for you around here, but if they're not available new, then I think the early 90s 4runners are your best bet.
 

Users who are viewing this thread

Back
Top Bottom