Positive camber after lift

[savirc]

Hello everyone,

Will a diff drop correct positive front camber after 2.5" lift somewhat? getting wear on outer edge of my new tires after only about 3000 miles and I'm not ready to buy aftermarket UCA's. Or is there an adjustment bolt on stock UCAs.

 

[montegofd3s]

The diff drop will not correct this. Only thing is to lower the truck or update the UCAs.

 

[hoser]

The stock (and aftermarket) UCA's have two bolts that adjust both camber and caster at the same time. Measure front end for 60mm of droop and then head to alignment shop. Also check for worn steering rack bushings and TRE's which can also cause uneven tire wear.

 

[ton504]

Stock eccentric bolts should give you enough adjustment.

 

[savirc]

Stock eccentric bolts should give you enough adjustment.

Thanks I was hoping there was something like that I could just adjust on the stock arms. I have a FSM hope the procedure is on there and its as easy as turning one bolt a specific direction otherwise I might just take it somewhere, I have never had good experiences with alignment shops, this would be the first time I take the hundy to one.