Parting Out parting out 1975 fj40 + body panels and fj60 knuckles + pro comp lift kit

[KP Cruisers]

Vehicle Model

1. 40 Series

I'm located in colorado springs all parts are pick up only and need to sell fast so shoot over offers. Pictures available upon request.

I have a brand new pro comp lift kit never installed leafs struts and hardware - 500 obo - sold

I have the following Body panels from real steel:

Driver rear quarter panel - 100 obo - sold
Passenger rear quarter panel(has slight rust from sitting in garage) - 100 obo - sold
Rear sill and sill cover(painted contact areas with zinc weldthrough primer) - 150 obo - sold
Fire wall patch - 50 obo - sold
Passenger upper wheel well - 80 obo - sold
4 wheel well supports - 20 per support - sold

I also have a set of knuckles and birfs from a fj60 along with calipers(rebuilt but would be better used as cores) - 300 obo

I also have almost all original parts off my 1975 fj40 if you're looking for anything let me know. 2f was running when I parked and it has the flat piston head along with 4 speed trans.

Some parts available:

OEM Roll bar: 150
Front seats(need foam and covers): 100
Rear jump seats(some rust but overall not bad): 100 for the set
Ambulance doors(dented and have rust): 80 for the set - sold
Front doors(have rust at bottom of doors and small holes from trim previous owner installed also need door cards): 80 per
windshield frame(minimal rust scratched windshield): 100 - sold

 

[CondeCruiser]

If you change your mind on shipping, I will buy the lift. Just need the springs.

 

[knuckle47]

I have to add the same statement…. If you decide to ship

 

[wesintl]

Sent a pm

 

[Land Shark]

Can you post pictures of the body panels? TIA

 

[KP Cruisers]

Can you post pictures of the body panels? TIA

 

[wileycoyote]

Is the fuel door different on an 81 fj40?

 

[KP Cruisers]

Is the fuel door different on an 81 fj40?

I believe so these panels are for 40s up to 78

 

[BKBRUCE]

Aloha, I'm looking for the bar and brackets located above the rear door or just below the hardtop( top reinforcement bar)This piece connects to the left and right side panels. i’m installing a hatch not the ambulance doors. Can anyone help?

 

[KP Cruisers]

Aloha, I'm looking for the bar and brackets located above the rear door or just below the hardtop( top reinforcement bar)This piece connects to the left and right side panels. i’m installing a hatch not the ambulance doors. Can anyone help?

I have the bar and brackets but my 40 has ambulance doors I'm not sure if they are different for the hatch

 

[40justin]

I'd do the windshield frame, I'll send a pm

 

[Fj40owen]

sent pm

 

[coloradocurtfj78]

I'm located in colorado springs all parts are pick up only and need to sell fast so shoot over offers. Pictures available upon request.

I have a brand new pro comp lift kit never installed leafs struts and hardware - 500 obo

I have the following Body panels from real steel:

Driver rear quarter panel - 100 obo
Passenger rear quarter panel(has slight rust from sitting in garage) - 100 obo
Rear sill and sill cover(painted contact areas with zinc weldthrough primer) - 150 obo
Fire wall patch - 50 obo
Passenger upper wheel well - 80 obo
4 wheel well supports - 20 per support

I also have a set of knuckles and birfs from a fj60 along with calipers(rebuilt but would be better used as cores) - 300 obo

I also have almost all original parts off my 1975 fj40 if you're looking for anything let me know. 2f was running when I parked and it has the flat piston head along with 4 speed trans.

Some parts available:

OEM Roll bar: 150
Front seats(need foam and covers): 100
Rear jump seats(some rust but overall not bad): 100 for the set
Ambulance doors(dented and have rust): 80 for the set
Front doors(have rust at bottom of doors and small holes from trim previous owner installed also need door cards): 80 per
windshield frame(minimal rust scratched windshield): 100

Can you message me I am interested in the rear sill and sill cover

 

[kunzma]

Could you post some pictures of the ambulance doors?

 

[coloradocurtfj78]

Could you post some pictures of the ambulance doors?

 

[kunzma]

Thanks. Looks like they are sold.