OME MT64

[Snobum72]

I run Bilsteins on my old Benz - they are tried and true.

 

[Snobum72]

Well, that would make sense - its the same technology.

 

[thatLC200]

The fronts are set to the longest travel setting (max setting).
Running the intermediate rear springs due to future drawers.

Initially, huge rake ~2.5 inches as the rear springs were totally unsprung. Added about 300lbs to rear and drive a couple hundred miles for the rear springs to settle.
Measured rake today and right at 1.5 inches.
This should stay constant once drawers and all my recovery gear is loaded.

Thanks for all the feedback. Would you mind to share what springs are you running in the front and rear? OME 2019 in front and 2721 in rear?

 

[thatLC200]

Look forward to this!! I talked with Amory at Slee a few weeks ago when out there about these..

My only hang-up was once you add 2 OME top-hats for the fronts, plus the cost of putting the fronts together, it was getting awfully close to BP51 money..

I do really like the snap ring height adjustment on these. I loved that feature on my gen 1 Raptor..

Are you able to use the stock top hats for the MT 64s?