Hey guys i'm intrested in putting the 4" rs ome lift on my 60 question is i'd like to put 35's on will i have enough lift and if not can i get an extra in or so by doing something and also is man a free the best place to get the lift from? thanks
ome lift
- Thread starter jclandcruiser
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
with 5" you will clear 35's at full flex with minimal rub (usually only when wheel turned and flexed hard)
I had 35's then dropped down to 33's cause of a killer deal i would have been dumb not to take. and im sitting right at 5" of lift
I had 35's then dropped down to 33's cause of a killer deal i would have been dumb not to take. and im sitting right at 5" of lift
I don't think you will get 4 inches out of the springs alone. Put some longer then stock shackles in and maybe a 1 inch body lift and you will fit 35's easier. Be advised though it would be best to re-gear as well.
How wide of 35"s will also be a determining factor.
Luke Porter is running tall skinny 35's on his HJ60 with the 3.5" lift. He used differnt backspacing on the wheels as well.
Luke Porter is running tall skinny 35's on his HJ60 with the 3.5" lift. He used differnt backspacing on the wheels as well.
- Thread starter
- #5
i plan on running 35 x 12.5 also cruiser what did u use to get the 5" of lift and do yall think with a v8 swap that i would still need to regear?
